Lantronix SGX 5150 Command Reference

5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 100
ber>
alarm email none
Specifies no email when the alarm turns on.
alarm message <text>
Sets the email message to be sent when the alarm turns on.
alarm reminder interval
<minutes>
Sets the time interval that messages will be sent while the alarm remains on.
clrscrn
Clears the screen.
default alarm email
Restores the default and no email is sent when the alarm turns on.
default normal email
Restores the default and no email is sent when the alarm turns off.
exit
Exits to the next higher level.
no alarm message
Removes the alarm email message.
no alarm reminder inter-
val
Only one message will be sent when the alarm turns on.
no normal message
Removes the normal email message.
no normal reminder in-
terval
Only one message will be sent when the alarm turns off.
normal email email
<number>
Specifies the email number to send when the alarm turns off.
normal email none
Specifies no email when the alarm turns off.
normal message <text>
Sets the email message to be sent when the alarm turns off.
normal reminder interval
<minutes>
Sets the time interval that messages will be sent while the alarm remains off.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
write
Stores the current configuration in permanent memory.
email (config-action-email:usb0 link state change) level commands
alarm email email <num-
ber>
Specifies the email number to send when the alarm turns on.
alarm email none
Specifies no email when the alarm turns on.
alarm message <text>
Sets the email message to be sent when the alarm turns on.
alarm reminder interval
<minutes>
Sets the time interval that messages will be sent while the alarm remains on.
clrscrn
Clears the screen.
default alarm email
Restores the default and no email is sent when the alarm turns on.
default normal email
Restores the default and no email is sent when the alarm turns off.
exit
Exits to the next higher level.
no alarm message
Removes the alarm email message.
no alarm reminder inter-
val
Only one message will be sent when the alarm turns on.
no normal message
Removes the normal email message.
no normal reminder in-
terval
Only one message will be sent when the alarm turns off.
normal email email
<number>
Specifies the email number to send when the alarm turns off.
normal email none
Specifies no email when the alarm turns off.
normal message <text>
Sets the email message to be sent when the alarm turns off.
normal reminder interval
<minutes>
Sets the time interval that messages will be sent while the alarm remains off.
show
Shows the current configuration.

Lantronix SGX 5150 Specifications

General

Certification	FCC ICES-003:2012 RED 2014/53/EU, EMCD 2014/30/EU, EN 300 328 V1.9.1, EN 301 489-1 V1.9.2, EN301 489-17 V2.2.1, EN 301 893 V1.8.1, EN 62311: 2008 AS/NZS CISPR 22, AS/NZS 4268: A1: 2013, AS/NZS 2772.2VCCI EN 55022:2010, EN 55024:2010, EN 61000-3-2:A2 2009, EN 61000-3-3: 2008 UL 60950/CSA 22.2 No. 60950, IEC 60950 CE LVD 2014/35/EU
LED indicators	Yes
Power requirements	9 - 30 VDC
Power over Ethernet (PoE)	No
Power consumption (typical)	1.9 W
Storage temperature (T-T)	-40 - 85 °C
Operating temperature (T-T)	-40 - 70 °C
Operating relative humidity (H-H)	5 - 95 %
Security algorithms	802.1x RADIUS, AES, EAP-FAST, EAP-PEAP, EAP-TLS, EAP-TTLS, FIPS 140-2, MSCHAPv2, TKIP, WPA, WPA2, WPA2-PSK, WPS
Authentication method	RADIUS
Ethernet LAN (RJ-45) ports	1
Supported protocols	IPv4/IPv6, TCP, UDP, ICMP, ARP, Auto-IP, DNS, (S)FTP
Frequency band	2.4 / 5 GHz
Cabling technology	10/100BASE-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11d, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s

Weight and Dimensions

Weight	350 g
Dimensions (WxDxH)	110 x 89 x 26 mm