EasyManuals Logo

Lantronix SGX 5150 Command Reference

Lantronix SGX 5150
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 172
firewall enable
Enables firewall on WAN interface.
ip address filter <num-
ber>
Change to config ip filter level.
ip address filter disable
Disables IP Address filtering.
ip address filter enable
Enables IP Address filtering.
mac address filter <num-
ber>
Change to config mac filter level.
mac address filter disable
Disables MAC Address filtering.
mac address filter enable
Enables MAC Address filtering.
no primary dns
Clears the name of the primary DNS server.
no secondary dns
Clears the name of the secondary DNS server.
operating mode disabled
Disables routing on WAN interface.
operating mode gateway
Enables routing with NAT on WAN interface.
operating mode router
Enables routing without NAT on WAN interface.
port forwarding rule
<number>
Change to config gateway port forwarding level.
primary dns <IP ad-
dress>
Sets the IP address of the primary DNS server.
router ip address <ip
address/cidr>
Sets the IP address of router. Formats accepted: 192.168.1.1 (default mask)
192.168.1.1/24 (CIDR) "192.168.1.1 255.255.255.0" (explicit mask)
router ipv6 address <ipv6
address/prefix>
Sets the IPv6 address of router. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
secondary dns <IP ad-
dress>
Sets the IP address of the secondary DNS server.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
show routing table
Show current routing table.
show status
Show gateway configuration and status.
static route <number>
Change to config gateway static route level.
virtual ip <number>
Change to virtual ip level.
wan interface <text>
Sets the preferred WAN interface. <text> = interface name. NOTE: When WAN interface is
wlan0, the LAN interfaces are eth0 and usb0. When WAN interface is eth0, the LAN inter-
faces are usb0 and Access Point. When WAN interface is usb0, the LAN interfaces are
eth0 and Access Point.
write
Stores the current configuration in permanent memory.
gre 1 (config-gre:1) level commands
clrscrn
Clears the screen.
default local network
Restores the default local network name.
default mtu
Restores the default Maximum Transmission Unit (MTU) size.
exit
Exits to the config level.
gre <instance>
Change to gre level.
ip address <text>
Sets the IP address and network mask.
local network <text>
Sets the local network name. <text> = local network name.
mtu <bytes>
Sets the Maximum Transmission Unit (MTU) size.
name <text>
Sets the name. <text> = name.

Other manuals for Lantronix SGX 5150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SGX 5150 and is the answer not in the manual?

Lantronix SGX 5150 Specifications

General IconGeneral
CertificationFCC ICES-003:2012 RED 2014/53/EU, EMCD 2014/30/EU, EN 300 328 V1.9.1, EN 301 489-1 V1.9.2, EN301 489-17 V2.2.1, EN 301 893 V1.8.1, EN 62311: 2008 AS/NZS CISPR 22, AS/NZS 4268: A1: 2013, AS/NZS 2772.2VCCI EN 55022:2010, EN 55024:2010, EN 61000-3-2:A2 2009, EN 61000-3-3: 2008 UL 60950/CSA 22.2 No. 60950, IEC 60950 CE LVD 2014/35/EU
LED indicatorsYes
Power requirements9 - 30 VDC
Power over Ethernet (PoE)No
Power consumption (typical)1.9 W
Storage temperature (T-T)-40 - 85 °C
Operating temperature (T-T)-40 - 70 °C
Operating relative humidity (H-H)5 - 95 %
Security algorithms802.1x RADIUS, AES, EAP-FAST, EAP-PEAP, EAP-TLS, EAP-TTLS, FIPS 140-2, MSCHAPv2, TKIP, WPA, WPA2, WPA2-PSK, WPS
Authentication methodRADIUS
Ethernet LAN (RJ-45) ports1
Supported protocolsIPv4/IPv6, TCP, UDP, ICMP, ARP, Auto-IP, DNS, (S)FTP
Frequency band2.4 / 5 GHz
Cabling technology10/100BASE-T(X)
Networking standardsIEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11d, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates10, 100 Mbit/s
Weight and Dimensions IconWeight and Dimensions
Weight350 g
Dimensions (WxDxH)110 x 89 x 26 mm

Related product manuals