Lantronix SGX 5150 - Page 294

5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 294
mode sequential
Sets sequential mode; will stop after first connection that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post is sent once only.
reminder interval
<minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
write
Stores the current configuration in permanent memory.
http post (config-action-http_post:on scheduled reboot) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post is sent once only.
reminder interval
<minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
write
Stores the current configuration in permanent memory.
http post (config-action-http_post:eth0 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post is sent once only.
reminder interval
<minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
write
Stores the current configuration in permanent memory.
icmp (config-icmp) level commands
clrscrn
Clears the screen.
exit
Exits to the configuration level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
state disable
Prevents ICMP packets from being sent or received.
state enable
Allows ICMP packets to be sent and received.
write
Stores the current configuration in permanent memory.
if 1 (config-if:eth0) level commands
clrscrn
Clears the screen.
default gateway <IP ad-
dress>
Sets the configurable gateway IP address to the default value.