5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 308
ip address filter <num-
ber>
Change to config ip filter level.
Removes the filter IP Address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
ip address filter 9 (config-ip_filter:9) level commands
Sets the action to ACCEPT.
Restores the default value of action (ACCEPT).
Exits to the config-gateway level.
Sets the filter IP Address.
ip address filter <num-
ber>
Change to config ip filter level.
Removes the filter IP Address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
key 1 (config-profile-security-wep-key:default_infrastructure_profile:1) level commands
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
Exits to the next higher level.
Sets WEP key. Each byte is represented by two adjacent hex digits. Bytes may run togeth-
er or be separated by optional punctuation: 123ABC "12 3A BC" 12,3A,BC 12.3a.bc
12:3a:bc Note that quotes must enclose the value if it contains spaces.
Sets WEP key. Each byte is represented by a single character. Note that quotes must en-
close the value if it contains spaces.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
key 2 (config-profile-security-wep-key:default_infrastructure_profile:2) level commands
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
Exits to the next higher level.
Sets WEP key. Each byte is represented by two adjacent hex digits. Bytes may run togeth-
er or be separated by optional punctuation: 123ABC "12 3A BC" 12,3A,BC 12.3a.bc
12:3a:bc Note that quotes must enclose the value if it contains spaces.
Sets WEP key. Each byte is represented by a single character. Note that quotes must en-
close the value if it contains spaces.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.