EasyManua.ls Logo

Lantronix SGX 5150 - Page 315

Lantronix SGX 5150
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 315
show history
Displays the last 20 commands entered during the current CLI session.
state disable
Disables command processing on line.
state enable
Enables command processing on line.
status update interval
<minutes>
Sets the status update interval.
write
Stores the current configuration in permanent memory.
link (config-wlan:wlan0) level commands
antenna diversity anten-
na 1
Set antenna selection to 1
antenna diversity anten-
na 2
Set antenna selection to 2
antenna diversity ena-
bled
Set antenna diversity to enabled.
apply wlan
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
band 2.4 ghz only
Sets the radio band to 2.4 GHz only.
band 5 ghz only
Sets the radio band to 5 GHz only.
band auto
Sets the radio band to Auto.
cancel wps
Cancels wi-fi protected setup operation.
choice <instance>
Enters the next lower level. Specify the instance for the next lower level.
clrscrn
Clears the screen.
debugging level debug
Sets the WLAN debugging level to Debug.
debugging level dump
Sets the WLAN debugging level to Dump, the most verbose option.
debugging level error
Sets the WLAN debugging level to Error, which shows only errors.
debugging level info
Sets the WLAN debugging level to Info.
debugging level warning
Sets the WLAN debugging level to Warning.
default antenna diversity
Restore the default value for antenna diversity.
default band
Restores the radio band to the default value (Auto).
default debugging level
Sets the WLAN debugging level to its default value, Info.
default scanning latency
Restores scanning latency to the default value (Standard).
exit
Exit back to interface configuration level
no scanning channel list
Clears the scanning channel list.
scan <ssid>
Scan the radio environment for networks.
scanning channel list
<text>
Sets the scanning channel list.
scanning latency en-
hanced throughput
Sets scanning latency to Enhanced Throughput.
scanning latency stand-
ard
Sets scanning latency to Standard.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
show wps information
Show the configuration received by wi-fi protected setup.
show wps information
with secrets
Show the configuration received by wi-fi protected setup with secrets.
show wps status
Show status of WPS operation.
smartroam
Enter smartroam configuration level
start wps
Starts wi-fi protected setup operation.

Other manuals for Lantronix SGX 5150

Related product manuals