5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 350
Exits to the config-dhcpd level.
Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
static leases 5 (config-dhcpd-static_leases:5) level commands
Exits to the config-dhcpd level.
Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
static leases 6 (config-dhcpd-static_leases:6) level commands
Exits to the config-dhcpd level.
Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
static leases 7 (config-dhcpd-static_leases:7) level commands