5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 351
Exits to the config-dhcpd level.
Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
static leases 8 (config-dhcpd-static_leases:8) level commands
Exits to the config-dhcpd level.
Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
static route 1 (config-staticroute:1) level commands
Restores the metric to default value.
Exits to the config-gateway level.
Set the friendly name for static route. <text> = friendly name
Sets the gateway for static route network.
Sets the route interface <text> = interface name
Sets the metric for static route. <number> = metric
Sets the IP address and network mask for static route network.
Clears the gateway for static route network.
Clears the route interface. The WAN interface is used if no interface is specified.
Clears the IP address for static route network.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Disables the static route.