Lantronix SGX 5150 - Page 369

5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 369
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
show local rsa key
Show Local RSA key
show logs
Show logs
show status
Show VPN status
state disable
Disables VPN tunnel.
state enable
Enables VPN tunnel.
type transport
Sets the transport type to transport.
type tunnel
Sets the transport type to tunnel.
unreachable host detec-
tion
Enters the next lower level.
username <text>
Sets the username. <text> = username.
vpn <instance>
Change to vpn level.
write
Stores the current configuration in permanent memory.
wep (config-profile-security-wep:default_infrastructure_profile) level commands
apply wlan
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
authentication open
Sets the type of authentication to open.
authentication shared
Sets the type of authentication to shared.
clrscrn
Clears the screen.
default authentication
Restores the authentication type to the default value (open).
default key size
Restores the key size to the default value (40 bits).
default tx key index
Restores the tx key index to the default value (1).
exit
Exits to the next higher level.
key <instance>
Enters the next lower level. Specify the instance for the next lower level.
key size 104
Sets the key size to 104 bits.
key size 40
Sets the key size to 40 bits.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
tx key index 1
Selects key 1 for transmission encryption.
tx key index 2
Selects key 2 for transmission encryption.
tx key index 3
Selects key 3 for transmission encryption.
tx key index 4
Selects key 4 for transmission encryption.
write
Stores the current configuration in permanent memory.
wlan profiles (config-profiles) level commands
apply wlan
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
clrscrn
Clears the screen.
create <profile name>
Create a new profile name
delete <profile name>
Delete existing profile by name
edit <profile name>
View or edit an existing profile
exit
Exits to the config level.
show
Show existing profile names
show history
Displays the last 20 commands entered during the current CLI session.
write
Stores the current configuration in permanent memory.