What to do if Lantronix Computer Accessories UBox software cannot establish a connection after pinging?
If the Lantronix Computer Accessories UBox software cannot establish a connection even after a successful ping, try temporarily disabling the firewall to see if communication is then established.
How to troubleshoot Lantronix UBOX 2100 Computer Accessories UBox software if it cannot find the hardware?
If the Lantronix Computer Accessories UBox software cannot find the UBox hardware, first verify that the UBox software's local UDP port is set to match the UDP port used by the UBox hardware (default is 10010). If you don't know the UDP port your software uses, set the Local UDP Port to 10010. If this doesn't work, reset your UBox hardware. If you still cannot see your UBox, troubleshoot network issues.
What to check if Lantronix Computer Accessories UBox communicates with a network but connection isn't established?
If the Lantronix Computer Accessories UBox is communicating with a network, but network communication between the computer and the UBox isn't established, ensure that the IP addresses of the PC and UBox are on different subnets. Also, verify physical network connections of the PC and UBox by checking network cable connections, ensuring switches/hubs are powered up, and confirming a network link light on both the PC and UBox.
Why Lantronix UBOX 2100 Computer Accessories UBox with static IP doesn't show connected users?
If the Lantronix Computer Accessories UBox, configured to use a static IP, doesn't show any connected users, verify that the computer trying to communicate with the UBox is on the same static IP Ethernet subnet and has the current UBox software installed. Also, check that the UBox software has the UDP port set correctly (default 10010) and that the computer does not have a personal firewall activated.
Why Lantronix Computer Accessories UBox with DHCP doesn't show connected users?
If the Lantronix Computer Accessories UBox obtained an IP address using DHCP but does not show any users connected to it, verify that the computer trying to communicate with the UBox is on the same DHCP Ethernet subnet or also received an IP address via DHCP and has the current UBox software installed. Also, check that the UBox software has the UDP port set correctly (default 10010) and that the computer does not have a personal firewall activated.
What to check if Lantronix UBOX 2100 UBox with Zeroconfig doesn't show connected users?
If the Lantronix Computer Accessories UBox obtained an IP address using Zeroconfig and does not show any users connected to the UBox, verify that the computer trying to communicate with the UBox is also on the Zeroconfig subnet and has the current UBox software installed. Also, check that the UBox software has the UDP port set correctly (default 10010) and that the computer does not have a personal firewall activated.
What is the maximum number of USB devices supported by a Lantronix Computer Accessories UBox?
One Lantronix Computer Accessories UBox supports up to eight USB devices.
General| Brand | Lantronix |
|---|---|
| Model | UBOX 2100 |
| Category | Computer Accessories |
| Language | English |
To Next Page
