xPico
®
240 Quick Start Guide
WHAT’S
IN THE
BOX
xPico 240
Evaluation Board
Firmware &
License Agreement
u.fl to RP-SMA Adapter
Cables* and Antennas
(XPC240300EK only)
* not shown
5V Power Supply with
Regional Adapters
2. HARDWARE INSTALLATION
2a. Attach the antenna(s) to the evaluation board (XPC240300EK only).
2b. Supply power to the evaluation board by plugging in the included
power adapter to the 5V DC Power Input (shown above).
2c. Move the ON/OFF power switch to ON.
2d. Proceed to the next page for instructions on how to configure the
xPico 240 using the web manager UI.
1. HARDWARE OVERVIEW
DB9 RS232
Serial Port
3.3V
Header
Peripheral I/O
Header
USB Port
Host/Device
Install
for USB Host
5V DC
Power Input
Power
On/Off
10/100
Ethernet
RJ 45
Wake
LED1
Status
xPico 240
Module
Power LED
Defaults
Reset
LED 3 Ethernet
Activity
LED 2
Ethernet Speed
Model shown: XPC240300EK
XPC2403 XPC2404
To Next Page
Need help?
General
