Need help?Do you have a question about the Lanzar VIBE X6 and is the answer not in the manual?
General| THD | <0.05% |
|---|---|
| S/N Ratio | >95dB |
| Crossover Type | Variable |
| Bass Boost | 0dB - 18dB |
| Subsonic Filter | 15Hz - 35Hz |
Connect to the positive terminal of your vehicle battery or other constant +12V source.
To be wired to the vehicle's chassis ground.
Connect to the remote control wire or antenna lead of the source unit for remote ON/OFF.
Selects front channel high-pass crossover frequency from 32 Hz to 800 Hz (or 320 Hz to 8K Hz).
Selects rear channel high-pass crossover frequency between 32 Hz and 800 Hz.
Extends front channel high-pass frequency range to 320 Hz - 8KHz when switch is set to "x10".
Selects low-pass crossover frequency for subwoofer channel between 50 Hz and 160 Hz.
Adjusts the front channel output signal level.
Adjusts the rear channel output signal level.
Adjusts the subwoofer channel output signal level.
Important safety measures to prevent short circuits and ensure correct installation.
Details on electrical connections like 12V, Ground, Remote, and signal inputs/outputs.
To Next Page
