To Next PageTo Next Page
Need help?Do you have a question about the LAPORTE 185 SKEET 12C and is the answer not in the manual?
Details on Laporte's industry reputation and history as a trap manufacturer.
Highlights the machine's simple, reliable, robust, and lightweight design.
Describes the 12-column magazine with a capacity of 700 targets.
Specifies the type of targets used, such as 12-column standard targets.
Details the lightweight and durable AU4G aluminum construction with epoxy finish.
Notes the ease of replacing electrical components and the use of an automotive fuse.
Mentions the safety guard for the throwing arm and its purpose.
Covers essential safety rules for installation and operation, including personnel training and machine handling.
Instructions for installing the trap on various bases and securing it properly.
Guidance on connecting the machine to a 12V power source, observing polarity.
Procedure for connecting the wired remote control to the control box.
Steps for correctly loading targets into the magazine.
Steps to test the machine's operation after setup, including arming and launching.
Diagnosing problems where the cocking motor does not start.
Troubleshooting when the motor runs but fails to cock the throwing arm.
Diagnosing why the machine, when cocked, does not launch targets.
Addressing issues where the throwing arm does not stop properly after decocking.
Troubleshooting problems related to remote control or radio transmitter functionality.
Identifying and resolving unusual sounds coming from the machine.
Resolving issues where targets are breaking upon launch.
Troubleshooting problems with the throwing plate, safety guard, or arm.
Addressing targets that fall broken onto the launching plate.
Diagnosing problems preventing targets from exiting the magazine correctly.
Instructions and parts list for fixing the safety guard to the rear of the machine.
Details of the plate card for the 185 PC model.
Details of the plate card for the 185 FO model.
Overview of the complete plate card for the 2015 control box model.
Ensuring the throwing arm is not bent before adjusting the plate.
Steps to adjust the throwing plate for optimal clay clearance.
Procedure for adjusting the knife separator to lightly rub the clay.
Instructions for adjusting the vertical angle of the target trajectory.
Procedure for adjusting the tilt or inclination of the throwing plate.
Diagram and instructions for connecting a wired remote control.
Diagram and instructions for connecting radio receivers or sono-pull devices.
Steps for installing the arming spring and adjusting its tension.
Details on different arming springs and their corresponding throwing distances.
Procedure for adjusting the vertical position of the micro-switch.
General adjustment steps for the micro-switch.
Adjusting the ATRDI instantaneous trigger system.
Steps for diagnosing and resolving issues with continuous target throwing.
General| Brand | LAPORTE |
|---|---|
| Model | 185 SKEET 12C |
| Category | Test Equipment |
| Language | English |
