30
Disposal
Local regulations must be observed for the disposal of the
product.
The
packaging should also be sorted by type and
disposed of in the relevant collection containers.
Further
information is available from your communal
disposal point.
Contact
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
GERMANY
Telephone: +49 (0) 202 - 429283-0
Telefax: +49 (0) 202 - 429283-20
E-Mail: info@eal-vertrieb.com
Maintenance
Check the bicycle carrier for wear before the start of every
journey. Defective metal parts and straps in particular must
be replaced.
Please refer to our customer service for the replacement
of parts.
Any modification of original parts and materials or the
c
onstruction of bicycle carrier can adversely affect its
safety and serviceability.
The
steel parts of the bicycle carrier are protected in the
works against corrosion by a powder-paint coating. If this
paint
coating is damaged, please have the damage
rectified
professionally as soon as possible.
Under normal conditions and use, the bicycle carrier only
requires cleaning, and is otherwise maintenance-free.
Adjustment of the quick-fastener
Carry out this maintenance operation only if the bicycle
c
arrier cannot be fitted firmly to the trailer coupling, as
described
in the chapter “Fitting”.
• Remove the bicycle carrier from the trailer coupling, as
described under “Dismantling”.
• Remove the dust protection cap.
• Loos
en the locking nut slightly, as shown in the
illustration.
•
Screw in the setting screw one quarter of a turn.
• Tighten the locking nut.
• Check whether the carrier is now firmly seated on the
trailer coupling, as described under “Fitting”. If not,
repeat the above steps.
Maintenance / Disposal / Contact
To Next Page
Loading...
