3. Sail Numbers
Sail Number positioning –
Standard sails
If you intend to race your Pico you will have to
attach your sail numbers.
1. Identify the sail number of your
LaserPerformance Pico by referring to the
builder’s serial number plate positioned on the
starboard (right hand) side of the aft/rear facing
mast buttress.
2. Cut the required sail numbers from the
generic digital 8’s supplied using the following
guidance:
3. Cut on the dotted line to make the specified
number.
4. Apply the sail numbers in a dry, clean and wind
free environment using the following guidance:
1. Lay the sail on a flat surface port side up.
2. e numbers on the starboard side are always
higher than the port side.
3. Measure 25 mm above the “P” of the Pico screen
print and draw the base line perpendicular to
the leach and blue sail panel.
4. Measure 70 mm from the leach and draw a line
parallel to the leach and perpendicular to the
base line previously drawn.
5. Position the port sail numbers starting with the
last digit squared to the base and leach lines.
6. e remaining numbers should be square to the
previous number and 60 mm apart.
7. Turn the sail over and mark a line on the
starboard side of the sail 100 mm above the port
numbers.
8. Starting with the first digit, work from the
leach line and position the sail numbers 60 mm
apart as above.
1
60mm
100mm
70mm
25mm
To Next Page
Loading...