This Torque adaptor can be used with any 1/2"D power bar or ratchet. The tool
enables the correct torque to be set on any fastener, ranging from 40-200Nm.
Calibration mode
The Adaptor will enter into Calibration mode if Mem and are pressed
simultaneously.
Battery Installation – 2 x AAA Batteries
• Low battery will show icon.
• Unscrew the retaining screws in the battery cap.
• Remove the old batteries.
• Screw the cap back into place.
Power
• Press and release the button to turn the adaptor on.
• The LCD panel will show trACE or PtoP.
• After 2 secs the LCD panel will show 0.0.
• The LCD will be displayed for 70 seconds before it will go off automatically.
Peak
• This will show the reading as the torque increases, and then hold at the highest
reading.
• With the power On, press and release the Peak-Trace button.
• When PtoP appears – release the button.
• Each time Peak is used the reading is stored up to 50 readings with the torque
setting.
• Each reading will be automatically numbered P50-01 (P01 will be the latest
number P50 the oldest).
Trace
• This will follow the torque as it is applied.
• With the power On, press and release the Peak-Trace button.
• When TRACE appears release the button.
2
www.lasertools.co.uk
Instructions
To Next Page
Loading...