Laser Green Laser - Operation and Technical Details; Operating Instructions; Technical Parameters; Maintenance and Notices

TECHNICAL PARAMETERS:
Green Laser Red Laser
Laser Diode: Green 532nm Laser Diode: Red 650nm
Power: AC 120V, 60Hz Power: AC 120V, 60Hz
Laser Power: Green <1.0mW Laser Power: Red <1.5mW
Eect: Static rey twinkling Eect: Static rey twinkling
Dimensions: max. dia. 10.6cm x L 13.5cm Dimensions: max. dia. 10.6cm x L 13.5cm
(max. dia. 4.17in x L 5.32in) (max. dia. 4.17in x L 5.32in)
Net Weight: 0.525KG (1 lb 16 oz) Net Weight: 0.525KG (1 lb 16 oz)
Gross Weight: 0.805KG (1 lb 77 oz) Gross Weight: 0.805KG (1 lb 77 oz)
Waterproof: IP65 Waterproof: IP65
MAINTENANCE:
Unplug the unit. Do not get any electrical parts of this product soaking wet. Rainy day use is
acceptable. Clean the lens regularly. It is recommended that it should be cleaned every 30 days.
NOTICES:
• Ingress protection: Enclosure is IP-65 weather resistant rated. Do NOT soak in water.
• Do not dismantle or repair the laser lighting. If there is any problem,
please contact customer service at 973.287.5136.
• Prevent the laser light from strong vibrations or blows to the light housing.
• Before powering on, make sure the connection at the Star Night Laser unit and
adapter are inserted properly and tightened securely.
• Do not turn on and turn o frequently, avoid leaving power on for a long time.
• Do not look at the laser source.
• Do not touch the adapter with wet hands or forcefully pull the power cable.
• The distance between lighting and casting medium should be more than 3 feet or 1 meter.
• When transporting, use the original package.
OPERATION:
Note: the Star Night Laser has a photocell and operates in dark/nighttime conditions. The presence
of light will turn the unit off. There may be a delay of on and off operation of about one minute.
This is normal operation of the photo cell and programming.
1. After Star Night Laser is plugged into the power source and positioned in place,
the unit can be turned on.
2. Press the On/Off Program Selection button once. The 1st of 8 programs should activate. Press
button to advance to the next program. Each pressing of the button will advance to the
next program. Cycle through the programs until desired program is reached.
3. 8 programs to choose from
1 Static Red
2 Blinking Red
3 Static Green
4 Blinking Green
5. Static Red & Green
6 Blinking Red & Green
7 Red & Green Alternating Blinking
8 Combination Cycle - changes every 10 sec.
* Hold for 3 sec. and unit turns off
4. Star Night Laser will turn off after 6 hours and turn on again automatically the next night.
5. Star Night Laser will restart at the last mode selected.
6. When used indoors, the light sensor will sample the light and if continuous light is present,
the unit will turn off after approximately one minute. To continue to use indoors, lower
the surrounding light.