59
USER MANUAL
BY LED BUTTON
This function allows the user to arm the system by excluding the internal volumetric
sensors and the comfort control (glass up).
To activate this function, the system must be disarmed; then proceed as described below:
Turn the ignition key / button to for a few seconds and then return it to " ": the ON OFF LED
will light up for 2 seconds.
Within 2 seconds, while the is on, press and release the button (when pressed the LED
LED goes out).
Wait for the to go out (2 seconds): a long acoustic signal will indicate the exclusion LED
of the volumetric sensors.
Get out of the car and press the lock button on the remote control.
The arming of the system will be indicated immediately by the fast flashing of the , 2 LED
short acoustic signals (if enabled) and many optical signals as many programmed by
the vehicle manufacturer.
LED
ON for
2 second
OFF
ON
Press for
2 second
ON
LONG
TONE
SIREN
x2 second
WAIT 2
SECONDS
LED OFF
ULTRASONIC SENSORS EXCLUSION
BY ORIGINAL REMOTE CONTROL
FUNCTION AVAILABLE ON SOME VEHICLES ONLY
( ) see vehicle’s list ISAUTO
This function allows the user to arm the system by excluding the internal volumetric
sensors and infrared sensors via radio. To activate this function, you need to:
Press the lock button on the vehicle's original remote control.
The will light up steadily to confirm the procedure. LED
After 4 seconds and before the starts flashing (within 10 seconds), press the LED
insertion button of the original remote control again.
To Next Page
Loading...
Need help?
General
