To Next PageTo Next Page
Need help?Do you have a question about the LaserLine LC800 and is the answer not in the manual?
General| Number of Beams | 4 |
|---|---|
| Power Source | 12-24V DC |
| Ingress Protection | IP66 |
| Type | Laser Beam Detector |
| Range | 800 meters |
| Detection Range | 800 meters |
| Laser Wavelength | 905 nm |
Details warranty terms, coverage, exclusions, and dispute resolution.
Compares features across different LC800 series models.
Wiring diagram for LC800/LC800B models with internal battery.
Wiring diagram for the self-powered LC801 model.
Wiring diagram for LC800-RF and LC801-RF models with wireless siren.
Important safety and installation precautions to prevent damage or malfunction.
Configuration and function of various input wires for sensors and signals.
Functionality and programming of various output signals for alarms and indicators.
Guidance on mounting, orientation, and adjustment of the ultrasound sensor.
Details system arming/disarming and alarm cause management via CAN-BUS.
Procedure for configuring the system with specific vehicle codes via button or PC.
Connecting and managing system via analog signals from door lock motor unit.
Schematic for arming/disarming system using vehicle direction indicators.
Learning mode for direction indicators and engine power signals.
Procedure for learning analog signals for arming/disarming.
Describes functioning modes of various alarm inputs like doors, bonnet, trunk, and sensors.
Details inhibition, exclusion, and bi-volumetric functions for alarm inputs.
Describes various operating modes of alarm outputs, including positive and negative signals.
Details programmable settings for outputs like hazard command, timed signals, and vehicle closure.
Explains passive arming, dashboard switching, and engine block relay default settings.
Procedure to disable arming/disarming acoustic signals using the electronic key.
Steps for learning new keys and deleting all learned devices.
Guide for updating vehicle software via PC connection using the programmer tool.
Details pre-alarm time, system armed status, and neutral time with alarm cycles.
Methods to exclude sensors using remote control, electronic key, or LED button.
How to identify the cause of the last alarm using LED indication.
Procedures for emergency disarming and total garage mode disarming via electronic key.
Step-by-step guide to disarm the system using the PIN code via the LED button.
Procedure to customize the emergency PIN code.
Instructions for storing the newly programmed PIN code.
Guide to diagnose and resolve common system activation and operation problems.
Information regarding European directives, homologation, and manufacturer notes.
Template for professional installers to certify system installation according to instructions.
