LaserLine LC800 User Manual

63
USER MANUAL
NEW EMERGENCY PIN-CODE PROGRAMMING
The original factory is 4-3-2-1.PIN-CODE
It is recommended, for obvious security reasons, to customize this code.
Remember that to customize the you must first enter the pre-set factory PIN-CODE PIN-
CODE PIN-CODE or the last modified , as described below.
NOTE: ZERO CODE IS NOT AVAILABLE
With the system disarmed, switch the panel on and off: the switches on for 2 LED
seconds.
Before the goes out, press the button 13 times. On the eleventh press wait for the LED
confirmation signal, at the twelfth press wait for 2 beeps and at the thirteenth press, 3
confirmation beeps.
PRESS THE
BUTTON FOR 11
TIMES
(programmable
functions table) wait
for the acoustic
notification
LED
ON for
2 seconf
OFF
ON
ON
x11
AFTER the
signalation
PRESS FOUR TIMES LED ON
ON HOLD FOR THE
SECOND DIGIT OF THE
DEFAULT PIN CODE
AFTER
2 SECOND
 After the thirteenth press wait for the to turn and turn on again and within 1 LEDOFF
second, start entering the first digit of the factory or the code previously set.PIN-CODE
 If the siren emits 5 short beeps, the factory code entered is , repeat then the WRONG
procedure from . Instead, if the siren has confirmed the correct code with the beginning
a long beep, wait the lights up and proceed to enter the new .LED PIN-CODE
x4
LED OFF
x1
1 BEEP
=
11 pressure
2 BEEP
=
12 pressure
AFTER the
signalation
x1
3 BEEP
=
13 pressure
Then repeat the operation for all the digits of the factory or the one previously PIN-CODE
set.
AFTER THE FOURTH
DIGIT
LED OFF
AFTER
2 SECOND
5 BEEP
SHORT
SIREN
BEEEEEP
LONG
SIREN
CORRECT
CODE
INCORRECT
CODE
First code:

LaserLine LC800 Specifications

General

Brand	LaserLine
Model	LC800
Category	Security System
Language	English