EasyManuals Logo

LaserLine LC800 User Manual

LaserLine LC800
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
59
USER MANUAL
BY LED BUTTON
This function allows the user to arm the system by excluding the internal volumetric
sensors and the comfort control (glass up).
To activate this function, the system must be disarmed; then proceed as described below:
Turn the ignition key / button to for a few seconds and then return it to " ": the ON OFF
LED will light up for 2 seconds.
Within 2 seconds, while the is on, press and release the button (when pressed the LED
LED goes out).
Wait for the to go out (2 seconds): a long acoustic signal will indicate the exclusion LED
of the volumetric sensors.
Get out of the car and press the lock button on the remote control.
The arming of the system will be indicated immediately by the fast flashing of the , LED
2 short acoustic signals (if enabled) and many optical signals as many programmed by
the vehicle manufacturer.
LED
ON for
2 second
OFF
ON
Press for
2 second
ON
LONG
TONE
SIREN
x2 second
WAIT 2
SECONDS
LED OFF
ULTRASONIC SENSORS EXCLUSION
BY ORIGINAL REMOTE CONTROL
FUNCTION AVAILABLE ON SOME VEHICLES ONLY
( ) see vehicle’s list ISAUTO
This function allows the user to arm the system by excluding the internal volumetric
sensors and infrared sensors via radio. To activate this function, you need to:
Press the lock button on the vehicle's original remote control.
The will light up steadily to confirm the procedure. LED
After 4 seconds and before the starts flashing (within 10 seconds), press the LED
insertion button of the original remote control again.
WITH ELECTRONIC KEY
This function allow to the user of arming the system alarm via electronic key (this
procedure exclud the internal sensor volumetric and infrared sensor via radio and
comfort command)
For activate this function, is neccesary that system is disarmed and the ignition key in
OFF position proceed as described below:
Inserting the electronic key into the receptacle
The status led will turn on for one second and a long signalation acustic for indicate
the esclusion of volumetric sensor.
Get ou of the vehicle and and close it with original remote control.
The system armed will be indicate immediatally by fast blinked LED, a short acustic
signalation (if enabled) and by optical signalation programmed by vehicle’s
manifacturer.
ATTENTION: if yhe key is
iserted for a second time, will
be activate the « activation
mode by electonic key» (fast
led blinkin)
BEEEEP
SIRENA
1X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LaserLine LC800 and is the answer not in the manual?

LaserLine LC800 Specifications

General IconGeneral
BrandLaserLine
ModelLC800
CategorySecurity System
LanguageEnglish

Related product manuals