07
Safety instructions
Dealing with electromagnetic radiation
• The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive
2014/30/EU.
• Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards or
interference or be subject to hazards or interference.
1 32
1 Detector tip 2 Pocket clip 3 Battery
compartment
ActivePen
EN
Symbols
Warning about hazardous electrical voltage:
Unprotected live components inside the device
housing are capable of posing a risk of electric
shock.
Protection class II: The test device has reinforced
or double insulation.
Overvoltage category III: Equipment in fixed
installations and for applications where specific
requirements with regard to the reliability and
availability of equipment have to be met, e.g.
circuit-breakers in fixed installations and devices
used in industrial applications which are
permanently connected to the fixed installation.
Additional information on use
Observe the technical safety regulations for working on electrical sys-
tems, especially: 1. Safely isolating from power supply, 2. Securing to
prevent system being switched on again, 3. Checking zero potential,
two-pole, 4. Earthing and short-circuiting, 5. Securing and covering
adjacent live components.
To Next Page
Loading...
Need help?
General
