13
MultiFinder Plus
EN
5
4
3
2
1
Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with electromagnetic
compatibility regulations and limit values in accordance
with EMC-Directive 2014/30/EU.
– Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards
or interference or be subject to hazards or interference.
– The measuring accuracy may be affected when working close
to high voltages or high electromagnetic alternating elds.
– Precautions: Do not use any other MultiFinder Plus within
a distance of 5 m. Do not use any electronic transmitters
or electric motors in the vicinity.
Open the battery compartmenton the
housing‘s rear side and insert a 9 V battery.
Correct polarity must be observed.
1 Insert battery
2 Operation
Switch on: Briefly press the On/Off button (4).
Switch off: Keep the On/Off button (4) pressed for 4 seconds.
AutoShutOff: The device will automatically switch itself off
about 2 minutes after the last measurement.
1 Maximum display
2 VTN display
3 Live wire warning
4 ON / OFF
Switching measuring mode
5 Manual calibration (CAL)
To Next Page
Loading...
