LaserLiner MultiScanner Plus - Page 23

23
MultiScanner Plus
If electric wires or metal or plastic pipes are located
near or in contact with a plaster fibreboard panel,
they may be identified by the MultiScanner Plus
as studs.
!
Tip 1: The device indicates the edge of the beam with “EDGE”
and the centre of the beam with “CENTER”.
Tip 2: The position where you start is important: First place the
tool in a position where you know there is no stud. Otherwise,
the message “ERROR” will appear in the display. To remedy:
Move the tool to another position a few centimetres away and
start measuring again.
Tip 3: To avoid interference while scanning, keep your
free hand and other objects at least 15 cm away from the
MultiScanner Plus.
Tip 4: The MultiScanner Plus will only find the outside edge of
double studs and headers which may be fitted around doors,
windows and corners.
Tip 5: Ensure that you have really detected a stud. To do so,
check on both sides whether other studs are present at equal
distances, usually at 30, 40 or 60 cm. Also check that it is a
stud by scanning at several places directly above and below
the position of the first find.
Tip 6: Textured ceilings: The ceiling must be covered with
cardboard to protect it.
Note: If an object is deep inside a wall, the device may not
indicate it clearly.
Manual
calibration
EN