LaserPoint Plus 2 - Plus 2 Specifications

LaserPoint s.r.l. - Plus 2 - Quick Start Guide - All Rights Reserved 10
3. P LUS 2 S PECIFICATIONS :
Detector Compatibility
Thermopile, photodiode, OEM
Input ranges
7 mV – 700mV full scale, in 9 ranges
A to D Sampling rate
64 Hz
A to D resolution
23 bit ADC resolution, 16bit processing resolution
Electrical accuracy
± 0.5%
Electrical input noise level
500nV
Input Offset Voltage drift (typical): -4nV/°C
Dynamic range
8 decades
Analog output
0.025 - 2 Volt, with 16-bit (0.0015% resolution.)
Analog output accuracy
±0.1% ±2mV relative to display
Dimensions
170H x 100W x 36-50D (mm)
Mass
380 g
Display
4.3" TFT LCD, 480 x 272 resolution with resistive touch
panel, high luminance. (96H x 55W mm)
Display digit height
15mm - 25mm Full Screen
Bargraph segments
250 pixel width
Battery
Rechargeable Li-Pol. 3.7V 3700mAh
Built in.
Battery charge time
7-8 hours if not operating
15-20 if operating
Battery runtime
> 9 hours
> 15 hours with stand-by display option
Supplied Charger
Input 100/240Vac 50/60Hz Out 5Vdc 1A,
Charging current is 0.5A (Plus 2 may be charged
through PC USB port).