10
Automatic adjustment:
As a rule, the spring base is equipped with
10 double sections.
The three components
• fibreglass reinforced support profile
• wings
• and side spring element
work together in the patented Lattoflex bed
system to permit maximum adjustment to
your own individual support requirements. In
other words, your Lattoflex spring base ad-
apts automatically to changing situations.
Shoulder zone:
Similarly, the large shoulder zone adapts
automatically. Thanks to the self-supporting
design, it permits maximum spring deflec-
tion when the need arises, thus relieving the
shoulder, particularly when lying on your
side.
Individual adjustment:
Even so, it makes sense to adapt and ad-
just certain things. For example, individual
adjustment of certain zones in your spring
base to support and relieve a hollow back.
Here for example it is possible to fit spring
blocks to the Lattoflex 200 spring base
(see point 2, next page).
The Lattoflex 200 wing spring system is
supplied ready mounted in the Lattoflex base
frame. Operating instructions for the base
frames for type 200 and 210 are contained
in this leaflet. Please heed the additional
instructions for all sitting frames from type
260 to 295.
Orientation: shoulder zone always at the
head end.
Placing in a bed:
Side support sections must not exceed
4 cm in width (middle frame: 8 cm)
Triangular supports up to maximum 15 cm
leg length.
Caution with spring bases from type 260:
If the spring base lies in triangular supports,
you are kindly asked to use the correspon-
ding installation kit (available as accessory).
The 4 self-adhesive foil sheets prevent noises
that may be caused by the spring base slip-
ping sideways. Remove the backing paper
from the adhesive layer. Then stick the foil
sheets on the left and right sides to the
head and foot of the bedstead so that the
spring base rests on the foil sheets.
Installation instructions Operating instructions
1
To Next Page
Loading...