© Elektronik-Systeme LAUER GmbH & Co. KG • Kelterstr. 59 • 72669 Unterensingen • Tel. 07022/9660-0 • Fax 07022/9660-103
23
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3.6 Important items regarding software installation
To carry out a successful re-installation you have to observe the following
items:
• For the set up please use the supplied operating system-CD.
• After the re-installation, the Chipset driver has to be installed first.
This can also be found on E:\drivers\Chipset.
• Install the graphic drivers (select E:\graphic\operating system).
The picture refresh rate has to remain at 60 Hz, as the TFT displays do
not have an electron beam for image formation, and therefore no
improvement is achieved from a higher setting. Higher settings can even
result in the destruction of the graphic board/display.
• install the touch drivers in accordance with the instructions.
Notice!
To avoid always having to re-start the installation procedure of the operating
system, we recommend image production of the new hard disc (for example
Norton Ghost, Drive Image etc.).
So, if needed, you can always fall back on the operational image.
Notice!
We recommend after operating the system for the first time that you
reproduce Start i.e. Emergency discs. These might be needed to restore
an operational system. Additionally you should make backup copies of
your own data and applications!
3 Putting in to operation
To Next Page
Loading...
Need help?
General
