22Seigla Assembly Guide Checklists
Check before each ride
• There’s no play in the headset:
To check for play in the headset, lock the front
brake with one hand. With your other hand,
place your fingers where the headset cup and
frame meet. Move the bike back and forth and
see if you can feel any play.
If there is play, loosen the two stem clamp
bolts using a 4 mm hex/Allen key (do not
remove them). Next, tighten the top cap with
a 6 mm hex/Allen key until there is no play
(be careful not to overtighten). Ensure the
stem is aligned with the front wheel, then
retighten the two stem clamp bolts to 6 Nm.
• Handlebar is firm.
• Hub thru-axles, pedals and other bolts are tight.
• Brakes are working properly and brake pads
are not excessively worn.
• Cables do not rub against the frame or fork.
• Chain is clean and lubed.
• Tire pressure is appropriate for the terrain
you plan to ride on.
• Frame, tires, rims and components show no
sign of damage wear or material fatigue.
• AXS battery is charged.
Always pay attention to any new sounds or if
you feel something new as your bike might need
some love and care. In case you crash please
examine the frame, fork, seatpost and handlebar
for any visible cracks as well as making sure
everything is aligned and tightened properly.
To Next Page
Loading...