Need help?Do you have a question about the LAUMAS TLB and is the answer not in the manual?
Steps for initial power-on, checking calibration status, and performing theoretical/real calibration.
How to enter parameter settings and perform theoretical calibration with load cell data.
Calibrating with sample weights and performing linearity adjustments up to eight points.
Adjusting filter settings to achieve a stable weight display.
Defining output relay operations and configuring digital input functions.
Performing tare operations to display net weight, which is lost on power-off.
Setting the weight to zero for small variations, lost on power-off.
Selecting analog output type, range, and defining minimum/maximum weight values.
Adjusting the analog output to indicate zero when the weight is zero.
Adjusting the analog output to indicate full scale at the maximum weight.
Configuring communication protocols, transmission speed, and instrument address.
Understanding RS485 network diagrams and applying termination resistors.
Configuring trigger points for relay switching based on weight values.
Setting hysteresis for smooth switching and preventing rapid relay cycling.
Explanations for various alarm codes like ErCEL, Er OL, Er Ad, etc.
Table detailing alarm responses for different serial protocols.
Managing menu access, temporary unlocking, and data deletion/restoration procedures.
To Next Page
General