LAUNCH CNC-603A Injector Cleaner & Tester User Manual
10
Figure 5.8 Figure 5.9 Figure 5.10
3） The system is running and at this time, the pressure can be adjusted via [Pressurization] and
[Depressurization] buttons. Automatic cleaning and draining is shown in the following figures:
4） The system will stop automatically after completion of test.
Flow Chart of Auto. Test
There are 3 modes for auto. test: Mode 1, Mode 2 and Mode 3. Mode 1 and Mode 2 are shown below; while Mode
3 is to run Mode 2 after running Mode 1.
To Next Page
Loading...