cause a fatal accident.
Z
Wear safety eye protection that meets ANSI standards.
z
Keep clothing, hair, hands, tools, test equipment, etc. away from all
moving or hot engine parts.
z
Operate the vehicle in a well-ventilated work area: Exhaust gases are
poisonous.
z
Put blocks in front of the drive wheels and never leave the vehicle
unattended while running tests.
z
Use extreme caution when working around the ignition coil, distributor
cap, ignition wires and spark plugs. These components create
hazardous voltages when the engine is running.
z
Put the transmission in P (for A/T) or N (for M/T) and make sure the
parking brake is engaged.
z
Keep a fire extinguisher suitable for gasoline/chemical/ electrical fires
nearby.
z
Don’t connect or disconnect any test equipment while the ignition is on
or the engine is running.
z
Keep the Creader 319 dry, clean, free from oil/water or grease. Use a
mild detergent on a clean cloth to clean the outside of the Creader
319, when necessary.
To Next Page
Loading...
