Wall fixing – in doubt seek professional advice
To avoid any risk of tipping, this unit must be safely secured to the wall (See Wall Mounting
Instructions)
- Do not stand or lean on this product.
- Make sure the area is clear when unpacking and positioning this product.
- This product is heavy, it should be assembled as near as possible to the point of use.
Take care when lifting to avoid personal injury and or damage to the product.
- Keep small children/pets away from assembly area. This product has small component parts that are a
choking hazard.
- Make sure you assemble this product correctly as per the instructions and ensure all fittings are tight.
- A minimum of two persons is require to lift the Drawer Chest into position
- We recommend that the packaging is used to protect the surfaces during assembly.
Step by step assembly instructions
Fig 1 Fig 2
Fig 1
Lay the unit on its back. We recommend that the packaging is used to protect the surfaces during this
process.
Place the plinth onto the bottom of the unit (Align the pre drilled holes on the plinth with the pilot holes on the
base panel) Secure the plinth using 8 Screws (A). Tighten with screw driver.
Fig 2
Carefully turn the assembled cabinet upright onto its feet.
A minimum of two persons will be required to do this.
Safety Advice and Assembly Recommendations
Wood
If fixing to wood make sure
that it isn’t chipboard as
screws can easily pull away
from the core structure
Brick or Masonry
Use an appropriate wall
plug provided you are
sure your wall is sound
Cavity wall
Special toggle wall plugs
are needed. Seek expert
advice