17
NOTE:
A short or worn trimming line will not cut well. If you notice reduced cutting performance,
you should check if there is enough trimming line on the spool. Remove the battery pack
before inspection. For spool replacement, refer to the Spool Replacement instructions in the
Maintenance section.
This trimmer is equipped with an automatic single line mechanism. To release more line, start and
stop the trimmer 2 - 3 times.
The trimming line extends automatically during every starting process. For the correct functioning
of the automatic line extension mechanism, the spool must stop completely before you restart
the trimmer. If the trimming line is initially longer than the cutting diameter, it is automatically
shortened to the right length by the line cutting blade.
NOTE:
Regularly check the trimming line for damage and whether the line still has the correct
length dened by the line cutting blade.
When no line end is visible:
Replace the line spool (see Spool Replacement instructions in the Maintenance section).
Adjusting the line length manually:
Switch off the trimmer and remove the battery. Press the line release button (
②
), pull the end of
the trimming line out and release line release button (Fig. 9). Avoid releasing very long length of
the trimming line.
The excess line that is cut off has a chance of hitting the user or other objects. Keep hands and
feet well away.
WARNING
OPERATION
After turning off the appliance, the trimmer head will continue to rotate for some time. Allow the
trimmer head to come to a complete standstill. Keep hands and feet well away. Risk of injury!
WARNING
Cutting Device - Advancing the Trimmer Line
(See Fig. 9)
To Next Page
Loading...