LawnMaster CLMF2437G - Page 52

17
NOTE: A short or worn trimming line will not cut well. If you notice reduced cutting performance,
you should check if there is enough trimming line on the spool. Remove the battery pack
before inspection. For spool replacement, refer to the Spool Replacement instructions in the
Maintenance section.
This trimmer is equipped with an automatic single line mechanism. To release more line, start and
stop the trimmer 2 - 3 times.
The trimming line extends automatically during every starting process. For the correct functioning
of the automatic line extension mechanism, the spool must stop completely before you restart
the trimmer. If the trimming line is initially longer than the cutting diameter, it is automatically
OPERATION
Risk of injury! Do not operate the appliance without the safety guard.
To operate the appliance, wear suitable clothing, eye and ear protection.
Prior to every use, check that the appliance is operative. Do not block the on/off trigger or the
lock-off switch. The switch and trigger must reliably turn off the motor when you release the switch.
Do not operate the appliance if one of the switches is damaged.
WARNING
Switching On and Off (See Fig. 8)
NOTE:
Maintain a rm stance and hold the appliance well with both hands and away from your
body. Before turning on the appliance, check that it will not touch any objects.
■ Make sure that the battery is installed properly.
■ Press the lock-off switch on either side and hold it in position. Activate the on/off trigger to
operate. Once started release the lock-off switch (Fig. 8).
■ To switch off, release the on/off trigger. There is no continuous operation mode.
After turning off the appliance, the trimmer head will continue to rotate for some time. Allow the
trimmer head to come to a complete standstill. Keep hands and feet well away. Risk of injury!
WARNING
Cutting Device - Advancing the Trimmer Line (See Fig. 9)
permitted temperature and the charging current ranges are reached, the battery charger will
automatically switch to charging.
After continuous or repeated charging cycles without interruption, the charger may warm up. This
is normal and does not indicate a technical defect of the battery charger.