LawnMaster CLMF4819A - GRASS COLLECTION BAG; Assembling and Installing the Bag

15
ASSEMBLY
ASSEMBLING THE GRASS COLLECTION BAG
Your LawnMaster
®
mower comes with a tool-less collection bag.
1. Check the grass collection bag before assembling to make sure there is no damage.
2. Pull the grass collection bag over the steel frame as shown (Fig. 3).
3. Pry the soft plastic clamping sleeves with your ngers and insert the steel frame into the sleeves as shown.
Ensure all sleeves are properly clamped with your ngers on the frame.
4. The completely assembled collection bag is shown as below (Fig. 4).
Fig. 3 Fig. 4
Grass Collection Bag
Metal Frame
Sleeve
INSTALLING AND REMOVING THE GRASS COLLECTION BAG
NOTE: When using the grass collection bag, do not install the mulching plug. The mulching plug MUST be
removed prior to installing grass collection bag.
Installing the grass collection bag:
1. Lift the rear safety ap and hold it in the position (Fig. 5).
2. Lift the grass collection bag by its handle and hook the rods of collection bag on the mower holder
under rear safety ap (Fig. 5).
3. Release the rear safety ap.
4. Make sure both rods are rmly seated on the holder and rear safety ap rests rmly against the top
of the grass collection bag.
Holders
Rods
Fig. 5
Mulching plug must be removed prior to
installing grass collection bag.