34
TROUBLESHOOTING
Problem Possible Cause Solution
Mower is hard to push.
High grass and low
cutting height. Rear of
mower housing and blade
dragging in heavy grass.
Raise the cutting height.
Mower vibrates
excessively and makes a
lot of noise.
The cutting blade is not
assembled securely.
Tighten the blade bolts.
The blade is not balanced.
Sharpen and balance the blade
following instructions in this manual (see
page 29). Or replace the blade.
The motor shaft is bent.
Stop the mower and remove the
batteries. Have the mower inspected
and repaired by an authorized service
center before restarting.
To Next Page
Loading...
