LawnMaster GLADIATOR PRO

Questions and Answers

M
Melissa SanchezAug 12, 2025
Why LawnMaster GLADIATOR PRO does not start?
- S
  Sandra SmithAug 12, 2025
  Your LawnMaster Lawn Mower might not start due to several reasons: a dirty air filter (clean or replace it), lack of fuel (fill the fuel tank), stale fuel (drain and refill with fresh fuel), water in the fuel (drain the tank and carburetor and refill with fresh fuel), a disconnected spark plug wire (connect it), a bad spark plug (replace it), a loose or broken blade adapter (tighten the blade bolt or replace the adapter), or a defective control bar (depress the control bar or replace it).
I
ismithAug 16, 2025
What to do if LawnMaster GLADIATOR PRO loses power?
- T
  Timothy JonesAug 16, 2025
  If your LawnMaster Lawn Mower loses power, it could be due to several factors. The rear of the mower housing or cutting blade might be dragging in heavy grass (set to a higher cut position), you might be cutting too much grass (set to a higher cut position), the air filter might be dirty (clean or replace it), there might be a buildup of grass and leaves under the mower (clean the underside), there might be too much oil in the engine (check the oil level), or your walking speed might be too fast (cut at a slower pace).
K
Kevin ThompsonAug 20, 2025
Why is LawnMaster Lawn Mower starter rope hard to pull?
- M
  Mike AllisonAug 20, 2025
  The starter rope on your LawnMaster Lawn Mower might be hard to pull because the engine flywheel brake is on when the control bar is released (depress the control bar to the upper handle before pulling the starter rope), the blade adapter is broken (replace the blade adapter) or the blade is dragging in the grass (move the lawnmower to cut grass or to a hard surface). If the engine crankshaft is bent, contact your LawnMaster dealer.
K
Kyle MossAug 23, 2025
How to fix LawnMaster Lawn Mower poor or uneven cut?
- W
  Willie ReyesAug 25, 2025
  A poor or uneven cut with your LawnMaster Lawn Mower can be caused by a worn, bent, or loose blade (replace the blade and tighten the blade bolt), uneven wheel heights (set all wheels at the same height), or a buildup of grass or leaves under the mower (clean the underside of the mower housing).
A
Audrey TaylorAug 27, 2025
Why is my LawnMaster GLADIATOR PRO hard to push?
- W
  William MarshallAug 27, 2025
  Your LawnMaster Lawn Mower might be hard to push if the grass is too high or the wheel height is too low (raise the cutting height), the rear of the lawnmower housing or blade is dragging in the grass (raise the rear of the lawnmower housing one setting higher), the grass catcher is too full (empty the grass catcher), or the handle height position is not right for you (adjust the handle height to suit).
L
Lisa PriceAug 31, 2025
Why LawnMaster GLADIATOR PRO grass catcher not filling?
- E
  Evan HerreraAug 31, 2025
  If the grass catcher on your LawnMaster Lawn Mower isn't filling, it could be because the cutting height is too low (raise the cutting height), the lift on the blade is worn off (replace the blade), or the catcher isn't venting air (clean the grass catcher).
L
Latasha LawrenceSep 4, 2025
What causes excessive vibration in a LawnMaster Lawn Mower?
- K
  Kevin ReyesSep 4, 2025
  Excessive vibration in your LawnMaster Lawn Mower can be caused by a worn, bent, or loose blade (replace the blade and tighten the blade bolt). If the engine crankshaft is bent, contact your LawnMaster dealer.
T
terrirobinsonSep 7, 2025
What causes loss of drive in LawnMaster Power Propelled Lawn Mower?
- E
  emily84Sep 7, 2025
  A loss of drive in your LawnMaster power-propelled lawnmower can be due to belt wear (check or replace the drive belt), the belt being off the pulley (check or reinstall the drive belt), or dirt in the drive pinions (clean the drive pinions).