LawnMaster GLADIATOR PRO - Page 9

A STEELFORT PRODUCT
9
• You can set the cutting height to the desired
height to t different terrain. Pull the lever out
from the catch, move to the desired position
and let it fall back into the catch.
WARNING
The lawnmower can only be used on
level lawns if the lowest cutting height is being used.
ATTACHING THE GRASS CATCHER
1. Lift the rear ap of the lawn mower and place
the grass catcher frame side hooks into the
slots of the lower handle brackets.
2. The grass catcher is secured to the lawn mower
housing when the rear ap is lowered onto the
grass catcher frame
CAUTION
Do not run your lawn mower without
clipping deector or approved grass catcher in
place. Never attempt to operate the mower with rear
door removed or propped open.
TO EMPTY YOUR GRASS CATCHER
1. Lift up on grass catcher using the frame handle.
2. Remove grass catcher with clippings from
under lawn mower handle.
3. Empty clippings from bag using both frame
handle and bag handle.
4.
NOTE: Do not drag the bag when emptying, this will
cause wear.
CAUTION
During operation of emptying clippings from grass
catcher, please wear protective gloves to prevent
environmental inuence on your skin.
CONVERTING YOUR MOWER
Your lawn mower was shipped ready to be used as
a mulcher. To convert to bagging/catching.
REAR BAGGING/CATCHING
1. Open rear ap and remove mulcher plug. Store
mulcher plug in a safe place.
2. You can now install the grass catcher (See to
attach grass catcher).
3. To convert to mulching, install mulch plug into
rear discharge opening of mower.
CAUTION
Do not run your lawn mower without clipping
deector or approved grass catcher in place.
Never attempt to operate the mower with rear door
removed or propped open.
BEFORE STARTING ENGINE
Your lawnmower is shipped without oil in the engine.
Engine holds approximately 0.6L