LawnMaster MEB1016M R - Page 13

13
ASSEMBLY
ADJUSTING HANDLE (See Figs. 2-7)
■ Fully loosen the four handle cam locs on both sides of the handle.
■ Pull up and bac on the lower handle and upper handle to raise the handles into operating position.
Make certain the handles snap.
■ Tighten the handle cam locs on both sides of the handle to secure.
Never operate the mower without the proper safety devices in place and working. Never operate the
mower with damaged safety devices. Failure to heed this warning can result in serious personal inj ury .
Fig. 2 Fig. 3 Fig. 4
Fig. 5 Fig. 6 Fig. 7
WARNING
If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to
heed this warning so could result in serious personal inj ury .
WARNING
Do not attempt to modify this product or create accessories not recommended for use with this product.
Any such alteration or modification is misuse and could result in a hazardous condition leading to
possible serious personal inj ury .
WARNING
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental
starting and possible serious personal inj ury .
WARNING
Handle Cam Locks
Handle Cam Locks
Fig. 2
Handle Cam Locks
Handle Cam Locks
Handle Cam Locks
Handle Cam Locks
Handle Cam Locks