Not to Scale
e use of non-clutching impact drivers to install this hardware will automatically void the warranty.
All product specications are subject to change.
Phone: 1-800-267-1236 www.lawrencehardware.com Fax: 1-800-892-7026
LH3000
Instructions
and Template
676 Petrolia Road
Toronto, Ontario M3J 2V2
1.Insert Plastichub
Into Door Hole Then
Insert The Latch
.
2.Install Base Plate.
3.Insert Spindle
With Spring.
4.Install Lever Handle.
What is in the Box
Installation Instruction
January 2017 LH3000 series (2017)
What is in the Box
\
1 Allen Key
1 privacy
pin if
required
M4x12 4pcs
M4x25 2pcs
M4x40 2pcs
M4x30 2pcs
8X8X40mm 2pcs
Design
Drawn
Check by
Approved by
Customer
Title
Modle
Part No.
Drawing No.
3D Angle Projection
Quantity
Scale
Material
Weight
version
N/A
Sheet of
2276.78
GA
A0
M4x12 4pcs
M4x25 2pcs
M4x40 2pcs
M4x30 2pcs
8X8X40mm 2pcs
Design
Drawn
Check by
Approved by
Customer
Title
Modle
Part No.
Drawing No.
3D Angle Projection
Quantity
Scale
Material
Weight
version
N/A
Sheet of
2276.78
GA
A0
M4x25 2 each
M4x40 2 each
Save for
Emergency Release
Standard Latch Faceplate2⅜” Privacy Shown Standard “D” Strike2¾” Passage Shown
Privacy
Pin
5. Installation Complete.
1. Insert Plastic hub
Into Door Hole en
Insert e Latch.
2. Install Base Plate. 3. Insert Spindle
With Spring.
4. Install Lever Handle.
To Next Page
Need help?
General