Need help?Do you have a question about the Lazer Safe LS-CS-M-069 and is the answer not in the manual?
General| Brand | Lazer Safe |
|---|---|
| Model | LS-CS-M-069 |
| Category | Power distribution unit |
| Language | English |
Covers safe installation, operation, and operator responsibilities for the Defender system.
Highlights crucial safety warnings for operating the press brake with the Defender system.
Prohibits alterations to the system and restricts access to electrical components.
Explains how the laser light band provides optical protection for the operator.
Details the continuous laser light band from the transmitter and its detection by the receiver.
Covers Class 1 Laser Device warnings and Class 3R laser radiation precautions.
Explains setting the laser to the correct distance below the punch tip for stopping performance.
Defines the mute point where optical protection turns off as material is detected.
Describes the default mode where all sensors are active for safe high-speed closing.
Explains system reaction to obstructions when the pedal is pressed from a standstill.
Details system response to obstructions during the tools' closing movement.
Deactivates optical protection for the entire stroke, allowing only safe speed operation.
Enforces specific conditions for machines not supporting dual speed operation.
Default setting for machines supporting dual speed and safe speed forcing.
Disables crawl speed, prohibits obstructions, and disables Tool Setup mode.
Disables crawl speed, prohibits obstructions, and enables Tool Setup mode.
Monitors stopping distance and speed, triggering an emergency stop if limits are exceeded.
Covers the complete alignment of the laser transmitter and receiver upon system installation.
Details checking laser horizontal alignment and distance below the new punch.
Explains the overrun test performed at start-up to verify safety performance.
Details the procedure for setting the mute point using sample material and the foot pedal.
Explains how to enable Field Muted mode, disabling optical protection for safe speed.
Details accessing Tool Setup mode for procedures without optical protection.
Covers manual E-Stop buttons, rear gate, and side gate triggers.
Details the Supervisor menu, requiring a password for system configuration.
Sets or changes the Supervisor level access code for menu protection.
Details demonstrating the mute point setting and resetting process.
Demonstrates Field Muted mode, explaining its function and password protection.
To Next Page