Need help?Do you have a question about the Lazer Safe PCSS-F Series and is the answer not in the manual?
Details the purpose and scope of the PCSS-F Additions Technical Manual.
Explains the meaning of symbols used for notes, cautions, and warnings in the manual.
Provides contact information for technical support services.
Details power supply connection for the I/O module via a 5-way terminal block.
Covers connections for emergency stop contactor and feedback via an 8-way terminal block.
Details connections for door and emergency stop switches via an 8-way terminal block.
Details valve monitor input connections via a 15-way terminal block.
Provides detailed technical specifications for standard, pulsed, and dual outputs/inputs.
Details the serial communication parameters and error counts for the ser4_a9 option.
Enables and controls the pressing beam movement based on solenoid valve control strategy.
Monitors system and press brake conditions to initiate an emergency stop.
Allows selection of error reset options for the PCSS software.
Provides options for monitoring valve status and fault conditions.
Allows selection of down switch options for operator station control.
Details how to activate the physical input for special mode operation selection.
Continuous check to ensure the press brake is not moving when the down switch is released.
Activates special tool features like flattening, hemming, or z-wing for operator safety.
General| Series | PCSS-F |
|---|---|
| Operating Voltage | 24 V DC |
| Application | Machine Safety |
| Type | Type 4 |
| Protection Height | Up to 1800 mm |
| Resolution | 14 mm, 30 mm |
| Detection Capability | Finger, Hand |
| Protection Rating | IP65 |
| Connection | M12 Connector |
| Standards | IEC 62061, ISO 13849-1 |
To Next Page