EasyManua.ls Logo

LD WSECO2 - User Manual

LD WSECO2
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
LD WSECO2 / LD WSECO2X2
UHF WIRELESS SYSTEMS
USER´S MANUAL
BEDIENUNGSANLEITUNG
MANUEL D`UTILISATION
MANUAL DE USUARIO
INSTRUKCJA OBSŁUGI
MANUALE D‘ USO
Question and Answer IconNeed help?

Do you have a question about the LD WSECO2 and is the answer not in the manual?

Summary

CONNECTIONS, CONTROLS AND INDICATORS: ECO2 RECEIVER

POWER LED

Indicates the system is connected to power and switched on.

ANTENNA LEDS A; B

Shows which antenna input (A or B) is active.

NORM LED

Lights up when an audio signal is present.

PEAK LED

Indicates the receiver is at the distortion limit; reduce transmitter signal.

VOLUME

Adjusts the receiver's volume level.

AF OUTPUT

Balanced line output with XLR socket for audio signal.

LOW VOLTAGE CONNECTOR

Connection point for the device's voltage supply.

MUTE LEVEL

Controls noise reduction/squelch to prevent interference.

UNBAL OUTPUT

Unbalanced line output with 6.3 mm jack.

CONNECTIONS, CONTROLS AND INDICATORS: ECO2 X2 RECEIVER

POWER LED

Indicates the system is connected to power and switched on.

RF-LED CH 1; CH 2

Indicates presence of a radio signal on channel 1 or 2.

AUDIO LED

Lights up when a radio signal is present on channel 1 or 2.

VOLUME CH 1; CH 2

Adjusts the volume for channel 1 or channel 2.

AF OUTPUT CHANNEL 1; CHANNEL 2

Balanced line output for channel 1 or channel 2 with XLR connector.

MUTE LEVEL CHANNEL 1; CHANNEL 2

Controls noise reduction for channel 1 or channel 2.

LOW VOLTAGE CONNECTOR

Connection point for the device's voltage supply.

2 IN 1 MIX UNBAL OUTPUT

Mixed unbalanced line output of channels 1 and 2 via 6.3 mm jack.

POCKET TRANSMITTER

TRANSMITTER ANTENNA

Antenna for optimal radio transmission; avoid touching or covering.

INPUT

3-pin mini XLR input for microphones and guitar cables.

MIC; 0 DB; -10 DB

Adjusts input sensitivity to prevent distortion.

ON; STANDBY;OFF

Controls the transmitter's power state and muting.

BATTERY STATUS LED

Red LED indicates battery status; replace batteries when lit.

ATTACHING THE PACK TRANSMITTER

Instructions for attaching the transmitter to a belt or strap.

HANDHELD TRANSMITTER

MICROPHONE HEAD

Describes the dynamic microphone capsule.

GAIN

Adjusts microphone volume and sensitivity to prevent distortion.

RF POWER H; L

Selects RF output power for transmission range and battery life.

BATTERY COMPARTMENT

Instructions for inserting AA batteries and removal for storage.

BATT LED

Red LED indicates battery status; replace batteries immediately.

ON;OFF SWITCH

Controls the transmitter's power state and indicates battery status.

BATTERY REPLACEMENT

Procedure for replacing batteries by unscrewing the cover.

MANUFACTURERS DECLARATIONS

MANUFACTURERS WARRANTY

Details the 2-year warranty for defects in material or workmanship.

LIMITATION OF LIABILITY

Defines Adam Hall's liability limits regarding product failure and damages.

REQUESTING WARRANTY SERVICE

Instructions on how to contact for warranty service.

EC DECLARATION OF CONFORMITY

States compliance with EU directives for R&TTE, EMC, and LVD.

PROPER DISPOSAL OF THIS PRODUCT

Guidelines for environmentally friendly product disposal in the EU.

ENVIRONMENTAL PROTECTION AND ENERGY CONSERVATION

Tips on energy conservation and reducing standby power.

LD WSECO2 Specifications

General IconGeneral
BrandLD
ModelWSECO2
CategoryMicrophone system
LanguageEnglish

Related product manuals