LDARC 200GT - Receiver Binding and Configuration; XM Receiver Binding Example; FS-RX2 A Receiver Binding Example

Receiver
XM Receiver example
FS-RX2A Receiver example
XM bind (default S.BUS),example(FRSKY X9D)
1. Open remote control, set D16 mode.
2. Hold receiver bind button to power, loosen until red and green light constant lighting.
3. Open remote control Bind, press “Enter” and wait a few seconds, then stop Bind when red light flash and green light
constant lighting.
4. Disconnect receiver power and power-on again, green light constant lighting means bind success.
.
.
LDARC 200GT Instruction Manual 2017-12-06 8 Pages-Page 4