LDARC 200GT - Component Wiring and Setup Diagrams; VTX and FC Wiring; ESC and Motor Connections

FC
Front Back
ESC
VTX
Motor
M4(CW) M2(CCW)
M3(CCW) M1(CW)
+ -
Power 2~4S
M1
M2
M3
M4
4.0V VIN GND VIDEO
25mW
100mW
- +
-
+ VIN
2S-4S Lipo
7V-18V
GND
LED Frequency table
Click the key change frequency point
Please attention ventilation cooling
Antenna
Q100-Mini 25mW/100mW 16CH VTX (2S-4S Lipo 7V-18V)
L=28mm,W=11mm,Weight=2.5g(Without camera and wire)
Note:pay attention to the direction of rotation of the motor
when installing the prop
LDARC 200GT Instruction Manual 2017-12-06 8 Pages-Page 3
Receiver
3V3 RC IN GND5V+
VIDEO
VTX
Connect these 3
pads to VTX when
use 2L tower(FC+ESC)
GND5V+
3V3 RC IN GND
RC IN GND5V+
DSMX
S.BUS/PPM
LED+Buzzer
5V(BUZZER+) LED(S) GNDBUZZER-
Camera
5V+ GND VIDEO
AUDIO
USB
BOOT
USB