To Next Page

To Previous Page

LDRTempof650Pro&TempoPC650ProUser’sManual–1.0

LucidellaRibaltasrl,ViaBerna14,46042CastelGoffredo(MN)Italy

Tel.+390376771777–fax+390376772140–emailinfo@ldr.it–webwww.ldr.it

• nevertouchthelampbulbwithbarehands.Oilandgreasecancontaminatethequartzsurfaceand

reducethelampperformanceandlife

• donotremovetheplasticprotectionaroundthelampuntilafterhavinginstalledthelamp

• openthetopslidingcoverbyturning(anti‐clockwise)the

¼turnfastener.Ato ol,suchasa

screwdriveroracoinwillbeneeded.Slidethecoveropentohavefullaccesstothelamphouse.

• insertthelampinthelampholder.MAKESURETHELAMPISCORRECTLYPOSITIONEDANDPERFECTLY

VERTICAL.

• carefullyclosethetopslidingcoverbyturning(clockwise)the¼turnfastener



7. INSTALLATION

Thisproductisfittedwithasuspensionstirruprotatingaroundthebodyoftheproduct,thusallowingthe

producttobeinstalledsuspendingorstanding.ThestirrupisfittedwithaØ12mmclearholeforthe

attachmentofahook

clamporastandpivot.

Beforeinstallingthisproductmakesurethestructureyouarefixingtheproducttocanwithstanditsload

andthetotalloadofanyotherunitinstalled.



1. Hangtheunittothestructureandfirmlytightentheclamp.

2. Fixthesafetybond



8. CONNECTTOTHEPOWERSUPPLY

• Makesuretheplugyouarefittingwithstandsthelamppowerload.

• Thisfixturemustbegrounded

• Toperformacorrectwiring,pleasenotethatthecoresinthismainsleadarecolour‐codedasfollows:

Ground:green+yellow–Neutral:blue‐

Live:brown



Incasethecoloursofthecoresdonotcorrespondtothecolouroftheconnectionpointsonyourplug,

pleaseproceedasfollows:

• Thegreenorgreenandyellowcoremustbeconnectedtotheconnectionpointmarked

withtheletterEorwiththesymbol

orcolouredingreenoringreen‐yellow

• ThebluecoremustbeconnectedtotheconnectionpointmarkedwiththeletterNorwith

thesymbol

orcolouredinblack

• ThebrowncoremustbeconnectedtotheconnectionpointmarkedwiththeletterLor

withthesymbol

orcolouredinred



• Beforeyoufinallypositionthisproductforuse,temporarilyconnectittoaproperlyfusedpowersupply

tocheckthelampworkscorrectly.

• Protecteachproductwithafusesuitabletothelampyouareusing.Shouldyouconnectthisproductto

adimmer

pack,pleasemakesurethisisfittedwithsuitableprotectivefuses.



9. CLEANINGANDMAINTENANCE

Toensuremaximumperformanceoftheproduct,aregularmaintenanceserviceshouldbecarriedout.

Pleasemakesuretheproductiscoldanddisconnectedfrompowersupplywhendoingthis.



• cleanallreflective

partssuchasreflector,mirrorandlensopeningtheproduct,ifnecessary.

• checkthelampandthelensandreplaceanyvisiblydamagedcomponent.

• cleanairductsinordertoallowproperventilationactivityontheproduct.

Brand	LDR
Model	Tempo f650 Pro Series
Category	Spotlight
Language	English

LDR Tempo f650 Pro Series User Manual

Table of Contents

Questions and Answers:

LDR Tempo f650 Pro Series Specifications