compartment and heat deformation of the bottom.
•
Check all gas supply fittings for leaks before each use. Do not use the appliance until all connections have been
checked and
do not leak.
•
Do not smoke while leak testing. Never leak test with an open
flame. Refer to leak test chapter in this
manual.
•
When lighting, keep your face and hands as far away from the
appliance as possible. If no igniting sparks
comes upon pressing the control button do not pursue attempting to ignite the appliance but check the
igniter battery condition.
•
Igniting should appear immediately if gas is supplied to the appliance. Do not attempt to ignite for
extended time and stop if you smell gas, and check the cause. If ignition is late, flames might burst out
of the opening causing damage or injury.
•
Minimum clearance from sides of unit to combustible
construction is 500mm.
•
Minimum clearance from back of unit to combustible
construction is 500mm.
•
The parts which have been sealed by the manufacturer should not be adjusted by the user.
•
Refer to local gas regulations for correct size of LPG bottle.
•
The minimum distances between the appliance and adjacent walls are 0.5m
•
The hose for the appliance should not exceed 1.5m or the length prescribed by local gas authorities.
•
The gas supply tubing or hose shall comply with local requirements in force and shall be periodically examined and
replaced as
necessary.
•
The hose and regulator assembly may not be provided with the appliance in some regions.
•
The hose should comply with the standard EN16436. The regulator should comply with the standard
EN16129. Local norms in force may prescribe other standards than these.
•
Check and suitably clean the inside of the oven before it is lit in order to avoid the emission of fire from the oils that
may have accumulated
during previous cooking.
•
The burner outlets should be checked for obstruction during previous cooking and cleaned regularly with
a soft wire brush. This is necessary to avoid obstruction and to allow for a good combustion.
• The position of the connection flexible tube must ensure that it is not subjected to twisting or
squeezing.
To Next Page
Loading...
