What to do if the cell voltage is too high in my LEAB Power Supply?
To address a high cell voltage issue in your LEAB Power Supply, stop charging the LPS to allow the cells to equalize. If the warning persists after 24 hours, it is recommended to contact your dealer.
How to fix 'Battery empty' error on LEAB Power Supply?
If your LEAB Power Supply displays a 'Battery empty' error, recharge the LPS to resolve the issue.
What to do if the LEAB LPS Power Supply shows 'Battery voltage too low'?
To resolve a 'Battery voltage too low' error in your LEAB Power Supply, recharge the LPS.
What does it mean when my LEAB Power Supply says 'Cell voltage is too low'?
If your LEAB Power Supply indicates 'Cell voltage is too low', recharge the LPS.
What to do if there is an overload at AC output on my LEAB LPS?
If your LEAB Power Supply shows an overload at the AC output, reduce the load at the AC output (230 V).
What to do if the input voltage (DC) is too high on my LEAB LPS?
If the input voltage (DC) is too high on your LEAB Power Supply, reduce the DC input voltage (12 V).
What to do if the input voltage (DC) is too low on my LEAB LPS?
If the input voltage (DC) is too low on your LEAB Power Supply, increase the DC input voltage (12 V).
What should I do if the discharge current at output (DC) is too high on my LEAB LPS Power Supply?
If the discharge current at output (DC) is too high on your LEAB Power Supply, disconnect or regulate the power source at the DC output (12 V).
What should I do if the charging current at output (DC) is too high on my LEAB Power Supply?
If the charging current at output (DC) is too high on your LEAB Power Supply, disconnect or regulate the power source at the DC output (12 V).
How do I fix a 'High voltage Overvoltage' error on my LEAB LPS?
If your LEAB Power Supply shows a 'High voltage Overvoltage' error, perform a restart. If the error persists, contact your dealer.
Guide for connecting the LPS to the 230-V mains supply.
Guide for connecting the LPS to the vehicle's 12-V battery.
Instructions for connecting devices to the 230-V AC output.
Instructions for connecting devices to the 12-V DC output.
Procedure for powering the LPS on and off via the menu.
How to charge the LPS using the 230-V mains connection.
Procedures for replacing DC and AC fuses in the LPS.
List of error codes, their descriptions, and recommended solutions.
General| Brand | LEAB |
|---|---|
| Model | LPS Series |
| Category | Power Supply |
| Language | English |
To Next Page