Hub 3.0 Installation
Instructions
User Interface
A. Wi-Fi Button – To Reset the Wi-Fi credentials of the LeakSmart Hub 3.0.
B. Power ON/OFF – A Switch to turn ON/ turn OFF the LeakSmart Hub 3.0.
Note: Battery is only backup supply. User must use power adapter in order to switch ON the device.
C. Factory Reset – Factory reset the LeakSmart Hub 3.0.
Note: All the paired sensor devices will be removed after factory reset.
D. User Indication LED – Single RGB color LED is used to provide user indications to show system status.
LED User indications are dened as per below table:
•
Primary Supply – 5V DC adapter supply.
•
Secondary Supply – Battery supply.
Setting up your LeakSmart System is as simple as launching
the LeakSmart App and pairing your devices.
User LED
Indication
Wi-Fi Button
Power On/O
Factory Reset
5v Power
Adapter Jack
page 1
Item# 8850830
Battery Compartment
(18350 Lion)
+
_
To Next Page
General