4
GETTING STARTED
ACTIVATE NORMAL PLAY MODE
This product is in Try-Me mode in the package and the unit can
only be turned on again by first pressing the Alpha Grooves
button. To activate normal play mode, please turn the toy
Off and then back On.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Find the battery covers located on the bottom of each foot. Use
a screwdriver to loosen the screws, and then open the battery
covers.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram
inside the two battery boxes. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery covers and tighten the screws to secure.
To Next Page
Loading...
Need help?
General