4
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the bottom of the unit and use a
screwdriver to loosen the screw and then open the battery cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten the screw to secure.
612203 manual REV.indd 4612203 manual REV.indd 4 09/30/2020 09:32:0009/30/2020 09:32:00
To Next Page
Loading...
